Step 1

Step one we begin by removing the screws from the outer case.  There are three on the bottom, and two on each side.  Be sure to remove the correct screws (as indicated) on the bottom.  All the screws are of identical size.

IMG_2007 IMG_2005

With a white J1 these screws are conveniently black, the ones on the side are white.

IMG_2008

You can then slowly open up the camera and remove the two side plastic pieces.  One may take a bit of a wiggle to get out, but don’t force it.  One of them will probably fall out on its own.  Make a note of which side is which, as it will make assembly easier.

IMG_0005

 

IMG_0009

 

 Back to Home page 

On to Step 2

Leave a Reply

Your email address will not be published. Required fields are marked *

Anti-Spam by WP-SpamShield

A Step by Step guide to convert your camera to infrared.